2024 : 11 : 21
Mehrdad Khamforoush

Mehrdad Khamforoush

Academic rank: Associate Professor
ORCID:
Education: PhD.
ScopusId: 21742691800
HIndex:
Faculty: Faculty of Engineering
Address: Department of Chemical Engineering, Faculty of Engineering, University of Kurdistan, Sanandaj, Iran.
Phone:

Research

Title
Supercritical fluid extraction from Priprioca: Extraction yield and mathematical modeling based on phase equilibria between solid and supercritical phases
Type
JournalPaper
Keywords
Cyperus articulatus L.; Priprioca; Supercritical fluid extraction; Mathematical modeling; Distribution coefficient
Year
2014
Journal The Journal of Supercritical Fluids
DOI
Researchers Tahmasb Hatami ، Lucinewton S. Moura ، Mehrdad Khamforoush ، Maria angela de alme Meireles

Abstract

This study aimed to investigate the supercritical carbon dioxide extraction of Cyperus articulatus L. (Priprioca). Before the experiments were performed, the raw material was cleaned, vacuum packed and maintained at -5 °C.The moisture content of the material was determined using an oven with forced air circulation operating at 105 °C.The material was then ground,and the mean diameter of the resulting particles wasdeterminedusinga set of standard sieves. Extraction was performedatpressures of 100 to 300bar, temperatures of 40 to 50°C, and extraction times up to 240 min using supercritical carbon dioxide as the solvent. For each load, approximately 50g of Priprioca waspacked into the extractor. According to the experimental results, the yields of extraction were significantly influenced by pressure and temperature.Additionally, this paper provides a mathematical model of the supercritical extraction of Priprioca. The employed mathematical model was based on the mass conservation law,which included two partial differential equations for the solute concentration in the solid and fluid phases. By applying a novel method, the distribution coefficient of the extract between supercritical fluid and solid phases was obtained using the criterion of equal fugacity at equilibrium. The model-predicted extraction yield was then compared with the corresponding experimental data. Additionally, the reasons for the deviations between the model and the experimental data under certain operational conditions are discussed.